MANUFACTURER
SUGISAKI Japan
CEDAR Digital Torque Screwdriver
Model: DID-05
Measuring range 2.0～500 mN･m 0.020～5 kgf・cm 0.020～4.5 lbf・in
Accuracy ±0.5％ (499 or less digits ±3 digits)
Display 4-digit LCD digital display
DID-05 Digital Torque Driver
For final tightening and checking of screws & bolts
Light and compact with built-in display!
To check the torque of small screw M0.8 ~ M2.0. Check the starting torque of rotating body such as volume & hinge.
To minimize the impact of the pressing force, the weight of the main part has been reduced to approximately 180.
A screw tightening counter function is also installed as standard.
Allows saving of 5 pass/fail criteria channels and allows easy setting changes by switching channels even when the tightening term changes.
Feature :
• The torque screwdriver is Ergonomic and light weight, yet ruggedly constructed
• Peak, Real Time and Peak Down measuring mode (selectable)
• 800 data memory
• Programmable High and Low set points with both audible beep and Green/Red LED indicator for
uniform torque tightening or GO/NO GO testing
• Programmable screw tightening counter
• Programmable Auto Zero function resets unit to zero for easy operation
• Both CW and CCW operate
• ASCII format output (USB)
• Runs on internal NiMH batteries (for 12 hours) Auto shut-off after 10 min. of non-use.
CEDAR Digital torque driver
Model: DID-05
Measuring range :2.0～500 mN･m/ 0.020～5 kgf・cm/ 0.020～4.5 lbf・in
Accuracy ±0.5％ (499 or less digits±3digit)
Display The 4 figures digital display of LCD
Picture: Cedar digital torque Srewdriver DID-05 ( 0.02 kgf.cm to 5 kgf.cm) at Semiki's warehouse.
Digital torque driver DID-05
For tightening and final checking of screws & bolts
Lightweight and compact with integrated display!
For checking torque of the small screw of M0.8 ~ M2.0. Checking the starting torque of the rotating body such as volume & hinge.
In order to reduce the influence of the pressing force, the weight of the main unit was minimized to about 180.
Screw tightening counter function is also standard installed.
Enable to save 5 channels of pass/fail judgment criterion, and enable to change settings easily by switch channels even if the tightening term changes.
Maintenance and calibration :
► We also have calibration certificate attached ( optional )
► Please re-calibrate after use for a certain period through our purchase store.
DISTRIBUTED BY:
Semiki instrumentation Co., Ltd
Email: sales@semiki.com
Office tel: +84 28 2253 3522
~DOING OUR BEST FOR YOU~
