ECT U.S.A Board Marker Probes
The BMP-1, BMP-2, BMP-3, BMP-4 Board Marker Probe patented design is for installation on bare board or loaded board test fixtures.
When your tester is equipped with the appropriate electronics and software, the BMP-1 scribes a permanent
.050” circle on every “passed” PCB tested. Boards that fail the test are not marked. The risk of human error
is eliminated in PCB testing and sorting.
ECT U.S.A
Board Marker Probes
Model:
BMP-1 / BMP-1-S / BMP-3
The board marker is used after an electrical test of electronic assemblies for optical marking of good parts. In this case, the tip of the marking unit is placed on the assembly. After the test is triggered by an electric current pulse, a rotary motion, which scores the perma- nent marking – a circle of 1.3 mm – into each “good” printed circuit board.
• The BMP Board Marker Probe patented design is for installation on bare board or loaded board test fixtures.
• When your tester is equipped with the appropriate electronics and software, the BMP scribes a permanent .050” circle on every “passed” PCB or device tested.
• Boards that fail the test are not marked. The risk of human error is eliminated in PCB testing and sorting.
• The unit requires less than .500” of fixture area. It is designed to mark board areas of bare glass (FR4), solder mask over glass or copper, or bare tinned copper.
• The BMP includes a mounting receptacle and a motor/transmission assembly.
• It can be easily removed from the receptacle for use in other fixtures.
• Spare receptacles and tip replacement assemblies are available. The thread between receptacle and housing is 7/16-20 UNF.
Maintenance and calibration :
► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI CORP
DISTRIBUTED BY:
Semiki instrumentation Co., Ltd
Email: sales@semiki.com
Office tel: +84 28 2253 3522
~DOING OUR BEST FOR YOU~