Cross Hatch Cutter BEVS 2202 Cross Hatch Cutter is designed and manufactured according to ISO 2409-1992, GB/T9286-98, B
BEVS Cross Hatch Cutter
Model: BEVS 2202
Cross Hatch Cutter is designed and manufactured according to
ISO 2409-1992, GB/T9286-98, B
• Check for correct selection of cutter type:
⇒ 2202/1C is designed for hard substrates with a coating up to 60 microns.
⇒ 2202/2C for hard substrates up to 60 microns, with the benefit of 11 teeth to produce 100 squares, enables % values to be obtained from the results.
⇒ 2202/3C intermediate, suitable for hard and softer substrates up to 60 microns.
⇒ 2202/4C for both soft & hard substrates with a coating thickness from 61 – 120 microns.
⇒ 2202/6C for both hard & soft substrates coating thickness 121 – 250 microns.
♦ Obtain Pressure Sensitive Adhesive Tape (for hard substrates).
► The Cross Cutters Tester conform with the requirements of: ISO2409-1992, GB/T9286-98,BS3900 E6, ASTM D3359.
► In order to achieve consistent results it is recommended that the test be conducted in accordance with the stated test methods.
Picture: BEVS 2202/2C full set
BEVS 2202/1C Cross Hatch Cutter (1MM 6 Blades)
BEVS 2202/2C Cross Hatch Cutter (1MM 11 Blades)
BEVS 2202/3C Cross Hatch Cutter (1.5MM 6 Blades)
BEVS 2202/4C Cross Hatch Cutter (2MM 6 Blades)
BEVS 2202/6C Cross Hatch Cutter (3MM 6 Blades)
Note: The Cross Hatch Cutters are not suitable for coatings thicker than
250 microns or for textured coatings
Maintenance and calibration :
► We also have calibration certificate attached ( optional )
► Please re-calibrate after use for a certain period through our purchase store. Local Vietnam : SEMIKI CORP
DISTRIBUTED BY:
Semiki instrumentation Co., Ltd
Email: sales@semiki.com
Office tel: +84 28 2253 3522
~DOING OUR BEST FOR YOU~